Extraordinary Maintenance; Spare Parts; Start-Up Certificate - Olsberg Tellus Aqua plus Mode D'emploi

•
Clean the glass pane with a special glass cleaner
or oven spray. Do not use any abrasive materi-
als.
Pull "A" out the combustion pan
15.1 Function CLEAN STOVE
This function makes it possible to clean the unit with-
out ashes escaping into the installation room as a
result of underpressure caused by the movement of
the door.
•
Press the OFF button for 2 seconds.
•
The flue gas fan will run at maximum speed,
which causes underpressure in the combustion
compartment so that the ashes do not escape
out of the combustion compartment.
•
It switches off automatically at the end of the
operation.
•
The function can be interrupted by pressing the
OFF button.
15.2 Complete cleaning
The unit must be completely cleaned at least month-
lyeach heating season.
Here, in addition to the cleaning measures already
described, the back wall of the combustion chamber
must be removed and the flue gas ducts that are
behind must be cleaned.
Take out back panel

16. Extraordinary maintenance

Comprehensive maintenance by a specialist is nec-
essary annually for continuously flawless operation of
the unit.
That is why the appliance reports the message
SPECIAL MAINTENANCE on the display after 2000
hours of operation.
Each time the unit is switched on, the acoustic signal
sounds and the message EXTRAORDINARY
MAINTENANCE alternates with the operating status
of the unit in the display.
This message can only be reset by an authorised
specialist.
We recommend signing a maintenance contract with
your authorised dealer or Olsberg Customer Service.
That is the only way to guarantee continuously opti-
mum efficiency of your unit.
If the annual maintenance is not performed certifiably,
Olsberg may exclude the customer from guarantee
services or warrantee claims.

17. Spare parts

Please note:
Please request any spare parts that are needed from
our authorised dealer. Exclusively original spare
parts may be used.
In order to process your order as quickly as possible,
we absolutely need the model and serial number
given on the unit's plate.
The unit's plate is found on the inside of the lid of the
pellet container.
To make sure that you always have easy access to
the numbers on the unit's plate, we recommend en-
tering them here before the installation:
Model number:
Serial number:

18. Start-up certificate

The start-up certificate documents the proper installa-
tion and start-up of the unit.
Instruction by a specialist is a basic requirement for
qualified operation of the unit.
A copy has to be sent to Olsberg company.
39
43/________________
__________________