Pioneer PDP-5004 Mode D'emploi page 18

Installation and Connections
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
layered on top of the horizontal synchronization signal.
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
On-screen setup is necessary after connection.
Please see pages 21 to 23.
14
EN
Connection to a personal
computer
Connection method differs depending on the computer
type. When connecting, please thoroughly read the
computer's operating instructions.
Before making connections, be sure to make sure that
the personal computer's power and display's main power
is off.
For the PC input signals and screen sizes that the display
is compatible with, please refer to the plasma display's
Operating Instructions.
When connecting to ANALOG RGB IN (INPUT1)
ANALOG RGB IN
AUDIO
INPUT1
INPUT1
D-Sub
R L
Connect the cable corresponding to the shape of the
input terminal on the display and the personal computer's
output terminal.
Secure by tightening the terminal screws on both units.
On-screen setup is necessary after connection.
Please see pages 21 to 23.
Note
Depending on the type of computer model being connected, a
conversion connector or adapter etc. provided with the computer
or sold separately may be necessary.
For details, please read your PC's instruction manual or consult
the maker or nearest dealer of your computer.