Appendix; Batch Setup Function; Saving Settings To The Usb Flash Drive - Epson Europe EB-1420Wi Guide D'installation

Batch Setup Function

Once the Configuration menu content has been set for one projector, you can use it to perform batch setup
for multiple projectors (batch setup function). The batch setup function is only for projectors with the same
model number.
Use one of the following methods.
• Setup using a USB flash drive.
• Setup using EasyMP Network Updater.
This guide explains how to use a USB flash drive.
c
•
The following content is not reflected by the batch setup function.
• Network menu settings (except for the Mail menu and the Others menu)
• Lamp Hours and Status from the Info menu
•
Perform batch setup before adjusting the projected image. Adjustment values for the projected image,
such as Keystone, are reflected by the batch setup function. If batch setup is performed after adjusting
the projected image, the adjustments you made may change.
•
By using the batch setup function, the registered User's Logo is set for the other projectors. Do not
register confidential information and so on as the User's Logo.
Caution
Performing batch setup is the customers responsibility. If batch setup fails due to a power failure,
communication error, and so on, the customer is responsible for any repair costs incurred.

Saving settings to the USB flash drive

c
•
Use a FAT format USB flash drive.
•
The batch setup function cannot be used by USB flash drives that incorporate security functions. Use
a USB flash drive that does not incorporate security functions.
•
The batch setup function cannot be used by USB card readers or USB hard disks.
a
Disconnect the power cord from the projector, and check that all of the projector's
indicators have turned off
b
Connect the USB flash drive to the projector's USB-A port
c
•
Do not connect a USB flash drive to the
•
Connect the USB flash drive directly to the projector. If the USB flash drive is connected to the
projector through a USB hub, the settings may not be saved correctly.
•
Connect an empty USB flash drive. If the USB flash drive contains data other than the batch setup
file, the settings may not be saved correctly.
•
If you have saved a batch setup file from another projector to the USB flash drive, delete the file
or change the file name. The batch setup function cannot overwrite a batch setup file.
•
The file name for the batch setup file is PJCONFDATA.bin. If you need to change the file name,
add text after PJCONFDATA. If you change the PJCONFDATA section of the file name, the
projector may not be able to recognize the file correctly.
•
You can only use single-byte characters for the file name.
port.
75

Appendix