Publicité
Les langues disponibles
Les langues disponibles
1
3
012229
012230
You can use both jig saw blades (B type) and recipro
saw blades according to your work. Insert the saw blade
straight into the blade clamp and tighten it by hex
wrench. Pull the saw blade lightly to make sure that the
saw blade does not fall off during operation.
To remove the saw blade, follow the installation
procedure in reverse.
Hex wrench storage
2
1
012167
When not in use, store the hex wrench. It is fixed by two
projections as shown in the figure to keep it from being
lost.
1. Saw blade
2. Blade clamp
3. Hole for recipro
saw blade
4. Hole for jig saw
blade
2
4
1. Hex wrench
2. Projections
OPERATION
012171
CAUTION:
Always
press the
•
workpiece during operation. If the shoe is held
away from the workpiece during operation, strong
vibration and/or twisting will be produced, causing
the blade to snap dangerously.
Always wear gloves to protect your hands from hot
•
flying chips when cutting metal.
Be sure to always wear suitable eye protection
•
which conforms with current national standards.
Always use a suitable coolant (cutting oil) when
•
cutting metal. Failure to do so will cause
premature blade wear.
Press the shoe firmly against the workpiece. Do not
allow the tool to bounce. Bring the saw blade into light
contact with the workpiece. First, make a pilot groove
using a slower speed. Then use a faster speed to
continue cutting.
012172
012173
You can use the switch lever or trigger according
•
to your work.
7
shoe firmly against the
Publicité
