Makita RJ01 Manuel D'instruction page 5

FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
013271
CAUTION:
Always switch off the tool before installing or
•
removing of the battery cartridge.
Hold the tool and the battery cartridge firmly
•
when installing or removing battery cartridge.
Failure to hold the tool and the battery cartridge
firmly may cause them to slip off your hands and
result in damage to the tool and battery cartridge
and a personal injury.
To remove the battery cartridge, withdraw it from the
tool while pressing the buttons on both sides of the
cartridge.
To install the battery cartridge, hold it so that the battery
cartridge front shape fits to that of the battery
installment opening and slip it into place. Insert it all the
way until it locks in place with a little click.
CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you.
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
Battery protection system
The tool is equipped with a battery protection system.
This system automatically cuts off power to the motor to
extend battery life.
The tool will automatically stop during operation if the
tool and/or battery are placed under one of the following
conditions:
Overloaded:
•
The tool is operated in a manner that causes
it to draw an abnormally high current. In this
1. Buttons
2. Battery
cartridge
5
situation, release the trigger switch on the
tool and stop the application that caused the
tool to become overloaded. Then pull the
trigger switch again to restart.
Low battery voltage:
•
The remaining battery capacity is too low
and the tool will not operate. If you pull the
switch trigger, the motor runs again but stops
soon. In this situation, remove and recharge
the battery.
Switch action
1
3
2
012169
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the switch lever/trigger
actuates properly and returns to the "OFF"
position when released.
To prevent the switch lever/trigger from accidentally
pulled, the lock-off lever/button are provided.
To start the tool, pull either switch lever or trigger.
For the switch lever, pull the lock-off lever and
•
then pull the switch lever to start the tool.
For the switch trigger, depress the lock-off button
•
and then pull the switch trigger to start to the tool.
The lock-off button can be pressed from either
right or left.
The tool speed is increased by increasing pressure on
the switch lever/trigger. Release the switch lever/trigger
to stop.
NOTICE:
Do not pull the switch lever/trigger hard without pulling
the lock-off lever/button. This can cause switch
breakage.
Lighting up the front lamp
012168
1. Lock-off button
2. Lock-off lever
3. Switch lever
4. Switch trigger
4
1. Lamp
1