Danby DAS090BAHWDB Manuel Du Propriétaire page 8

OPERATING INSTRUCTIONS
SETTING VERTICAL ANGLE OF AIR FLOW
While the appliance is on, use the SWING/DIRECT
button to set the vertical angle of the air fl ow.
1. Press the SWING/DIRECT button once to
activate the louver. Each press of the button will
adjust the louver by 6°.
2. To make the louver swing up and down
continuously, press and hold the SWING/
DIRECT button for 3 seconds. Press it again to
stop the continuous swing.
SETTING HORIZONTAL ANGLE OF AIR
FLOW
The horizontal angle of the air fl ow must be set
manually. Grip the defl ector rod and manually adjust
it to the preferred direction.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set the
louver at an extreme vertical angle for a long period
of time. Water can condense on the louver blade
which can then drip on the fl oor or furnishings.
When using COOL or HEAT mode, do not set the
louver at an extreme vertical angle for a long period
of time. This can cause reduced performance due to
restricted air fl ow.
Do not force the louver to move or adjust the louver
by hand. This will cause the louver to be out of sync
and it will not function correctly. If this occurs, turn off
the appliance and unplug it for a few seconds and
then restart the appliance. This will reset the louver
position.
Do not put fi ngers in or near the blower
and suction side of the appliance. The
high-speed fan inside the appliance can
cause serious harm or injury.
7
CAUTION