Publicité
Les langues disponibles
Les langues disponibles
Removing Packaging
NOTICE: To prevent damage to your floor keep the unit
in its packaging base until ready to be placed in the
cabinet opening. Do not slide the unit across the
flooring.
Different models use different packaging materials.
Actual brackets may look differently. Bracket remains in
packaging base.
1
Cut straps on outside of box.
2
Remove cardboard box.
3
Remove all top and side cardboard and Styrofoam
braces.
4
Place oven in front of cabinets where it is to be
installed.
Install Appliance
Note: The appliance is heavy. It is advisable to install it
with a second person.
NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical
connections.
Mount to Cabinet
Use the included retaining plate and two screws to
fasten on the side bottom of the hinge side in the
installation cabinet. Mark the screw midpoint, the
retaining plate must be positioned precisely. Depending
on the installation situation, on partition floor or heating
drawer WS4.., turn the retaining plate by 180°. When
pushed into the cupboard, the appliance snaps into the
retaining plate.
If there is no fitted shelf above the appliance, secure the
appliance against tipping over when the door is opened.
Fit two standard angles
3
at 17
/
" (450 mm) depth inside the cabinet.
3
4
1
Do not kink or trap the connecting cable, or route it
over sharp edges.
2
Centre the appliance.
There must be an air gap of
the appliance and adjacent cabinets.
3
Using a spirit level, adjust the appliance so that it is
perfectly level.
/
" (5 mm) above the appliance
16
/
" (5 mm) between
3
16
7
Publicité
