Tanaka TCG 40EAS P Instructions De Sécurité Et Mode D'emploi page 9

Installation of cutting blade (Fig. 12)
When installing a cutting blade, make sure that
there are no cracks or any damage in it and that the
cutting edges are facing the correct direction.
Align the notch hole of the cutter holder with the
hole on the gear case (Top the gear case) and insert
the Allen wrench to stop turning. Turn the fi xing nut
clockwise and remove the fi xing nut, protection
cover, cutter holder cap, and toothed lock washers.
The installation of the cutting blade is as follows:
insert the Allen wrench into the notch hole of
the cutter holder and the hole on the gear case.
Then, install the cutting blade (check the installing
direction, as referring to Fig. 14), the cutter holder
cap, protection cover and toothed lock washers onto
the cutter holder in this order. Finally, tighten the
fi xing nut securely by turning counterclockwise with
the Combi box spanner. (Fig. 12)
Fig. 12
Fig. 14
CAUTION
● When installing the cutting blade, set its
center hole to the convex part of the cutter
holder and hold it with the concave surface
of the cutter holder cap. Then, tighten the
fi xing nut to prevent the cutting blade from
being eccentric. (Fig. 12)
After installing the cutting blade, be sure
to remove the Allen wrench and Combi box
spanner.
● Before operation, make sure the blade has
been properly installed.
● Cutter holder cap under a cutting blade,
check it for wear or cracks before operation.
If any damage or wear is found, replace it, as
it is an article of consumption.
NOTE
The blade must be retained with a new cotter pin
each time installed. (Fig. 12)
Installation of nylon head (Fig. 15)
Attach cutter holder (11) to the gear case. Insert an
Allen wrench into the hole in the gear case to attach
winding protector (12) and attach nylon head (13) by
turning it clockwise.
NOTE
Since cutter holder cap is not used here, keep it
for next metal blade use.
Fig. 13
11
12
13
Fig. 15
G
B
F
R
E
S
9