Tanaka TCG 40EAS P Instructions De Sécurité Et Mode D'emploi page 16

NOTE
○ The nylon head is designed for nylon lines with
an outer diameter of 0.1˝ (2.5 mm). Do not use
nylon lines with a diff erent outer diameter.
○ Make sure that the right and left nylon lines are
of equal length since vibrations will otherwise
increase.
Maintenance schedule
Below you will fi nd some general maintenance
instructions. For further information please contact
your Tanaka dealer.
Daily maintenance
○ Clean the exterior of the unit.
○ Check that the harness is undamaged.
○ Check the blade guard for damage or cracks.
Change the guard in case of impacts or cracks.
○ Check that the cutting attachment is properly
centred, sharp, and without cracks. An off -centre
cutting attachment induces heavy vibrations that
may damage the unit.
○ Check that the cutting attachment nut is
suffi ciently tightened.
○ Make sure that the blade transport guard is
undamaged and that it can be securely fi tted.
○ Check that nuts and screws are suffi ciently
tightened.
Weekly maintenance
○ Check the starter, especially the cord and return
spring.
○ Clean the exterior of the spark plug.
○ Remove it and check the electrode gap. Adjust it
to 0.024˝ (0.6 mm), or change the spark plug.
16
Fig. 40
Fig. 41
○ Clean the cooling fi ns on the cylinder and check
that the air intake at the starter is not clogged.
○ Check that the angle gear is fi lled with grease up
to 3/4.
○ Clean the air fi lter.
Monthly maintenance
○ Rinse the fuel tank with gasoline.
○ Clean the exterior of the carburetor and the space
around it.
○ Clean the fan and the space around it.