Table Des Matières - Tanaka TCG 40EAS P Instructions De Sécurité Et Mode D'emploi

MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand
their meaning before use.
It is important that you read, fully
understand and observe the
following safety precautions and
warnings.
Careless or improper use of the
unit may cause serious or fatal
injury.
Read, understand and follow all
warnings and instructions in this
manual and on the unit.
Always wear eye, head and ear
protectors when using this unit.
Keep all children, bystanders and
helpers 15 m away from the unit.
If anyone approaches you, stop
the engine and cutting attachment
immediately.
Be careful of thrown objects.
Contents
WHAT IS WHAT .................................................... 3
WARNINGS AND SAFETY INSTRUCTIONS ........ 4
SPECIFICATIONS ................................................. 6
ASSEMBLY PROCEDURES ................................. 7
OPERATING PROCEDURES .............................. 10
MAINTENANCE .................................................. 13
2
Shows maximum shaft
speed. Do not use the cutting
attachment whose max rpm is
below the shaft rpm.
Gloves should be worn
when necessary, e.g., when
assembling cutting equipment.
Use anti-slip and sturdy
footwear.
Blade thrust may occur when
the spinning blade contacts a
solid object in the critical area. A
dangerous reaction may occur
causing the entire unit and
operator to be thrust violently.
This reaction is called blade
thrust. As a result, the operator
may lose control of the unit
which may cause serious or
fatal injury. Blade thrust is more
likely to occur in areas where it
is diffi cult to see the material to
be cut.