Checking The Blade; Loading Nylon Line - Shindaiwa T3410 Manuel D'utilisation

Maintenance
T: Idle speed adjustment screw

Checking the blade

Loading nylon line

Every unit is test run at the factory and the carburettor is fine
tuned for maximum performance.
Before adjusting carburettor, clean or replace air filter, start en-
gine and run several minutes to bring it to operating temperature.
To adjust the carburettor proceed as follow:
Start engine and turn "idle" speed adjustment screw clockwise
until the cutting attachment begins to turn, then turn the screw
anticlockwise until the cutting attachment stops turning. Fur-
thermore, give the screw an additional 2 turn. Repeat the proc-
ess of accelerating to full throttle and return to idle a few times.
Check that the cutting attachment stops moving at idle.
If a tachometer is available, the engine idle speed should be
final adjusted to 3000 r/min.
Use only blade designated for this model by the manufacturer.
When a crack is noticed on the blade, do not use it but replace
with a new one.
Ensure that the blade is correctly fitted in accordance with the
instructions.
When the cutting blade becomes dull due to wear reverse it for
further use.
When chip or bend occurs on the blade, vibration will increase.
Replace with new one.
When filing the blade file 3 cutting edges evenly using a flat file
as shown in the illustration.
Otherwise, the balance will be lost and vibration will increase.
1. Cut one piece of line to recommended length.
2.4 mm dia. - 6 m
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of nylon line into an eyelet, and push line
equal distance through nylon line cutting head.
4. Hold nylon line cutting head while turning knob clockwise to
wind line onto spool until about 13 cm of each line remains
exposed.
32