Shindaiwa T3410 Manuel D'utilisation page 20

Before you start
1. Shaft bolt
2. Bolt guard
3. Holder B
4. Output shaft
1. Safety clip
1. Blade
5. Safety clip
6. Holder A
7. L-wrench
1. Turn the product upside down so the gearcase output shaft
is facing UP and remove the shaft bolt, bolt guard and holder
B from the gearcase shaft.
2. Align the hole in blade holder A with the matching hole in the
gearcase flange and then temporarily lock the output shaft
by inserting a L-wrench through both holes.
3. Slide the safety clip off-center.
4. Fit the blade over the safety clip and then center it over the
flange on holder A.
Install the blade so its printed surface is visible to the
operator when the brushcutter is in the normal operat-
ing position.
The blade must fit flat against the holder flange. The
blade mounting hole must be centered over the raised
boss on blade holder A.
NOTE
When installing certain blades, it may be necessary to tempo-
rarily remove the safety clip.
18
CAUTION
WARNING