Getting Started; To Turn The Power On; Setting The Clock; General Control - Pioneer X-CM32BT-K Mode D'emploi

Masquer les pouces Voir aussi pour X-CM32BT-K:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 38

Getting started

Chapter 4:
Getting started

To turn the power on

Press the
STANDBY/ON to turn the power on.
After use:
Press the
STANDBY/ON to enter the power stand-by mode.
Note
• In standby mode, if iPod/iPhone/iPad is connected, the
unit turns charge mode.

Setting the clock

STANDBY/ON
OPEN/CLOSE
CD
USB
TUNER
AUDIO IN
iPod
BT AUDIO
CLOCK/TIMER
SLEEP
EQUALIZER
1
2
3
P BASS
1
Press
STANDBY/ON to turn the power on.
2
Press CLOCK/TIMER on the remote control.
"CLOCK" is shown on the main display.
3
Press ENTER.
4
Press
to set the day, then press ENTER.
5
Press
to set the hour, then press
ENTER.
6
Press
to set the minute, then press
ENTER to confirm.
7
Press ENTER.
To confirm the time display:
Press the CLOCK/TIMER. The time display will appear for
about 10 seconds.
To readjust the clock:
Perform "Setting the clock" from step 1.
Note
• When power supply is restored after unit is plugged in
again or after a power failure, reset the clock.
DISPLAY
FOLDER
TUNE+
ENTER
MEMORY
MENU
/PROGRAM

General control

Input function

When the INPUT on main unit is pressed, the current function
will change to different mode. Press the INPUT repeatedly to
select desired function.
CD
FM
LINE
AUDIO IN

Display brightness control

Press DIMMER to dims the display brightness. The
brightness can be controlled in four steps.

Volume auto set-in

If you turn off and on the main unit with the volume set to 31
or higher, the volume starts at 30 and sets in to the last set
level.

Volume control

Turn the volume knob towards VOLUME (on main unit) or
press VOLUME +/– (on remote control) to increase or
decrease the volume.
CAUTION
• The sound level at a given volume setting depends on
speaker efficiency, location, and various other factors. It
is advisable to avoid exposure to high volume levels. Do
not turn the volume on to full at switch on. Listen to
music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.

Muting

The volume is muted temporarily when pressing the MUTE on
the remote control. Press again to restore the volume.
AM
USB/IPOD
BT AUDIO
IPOD
(X-CM42BT only)
04
13
En

Publicité

Table des Matières
loading

Table des Matières