Light Indicators - DeWalt DCB1800 Guide D'utilisation

Minimum gauge for Cord sets
Volts Total length of Cord in Feet (meters)
120 V 25 (7.6)
240 V 50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
Ampere Rating
More not
Than More
Than
0 6 18
6 10 18
10 12 16
12 16 14
• Do not place any object on top of the portable
power station/charger nor place the portable power
station/charger on a soft surface that might block
the ventilation slots and result in excessive internal
heat. Place the portable power station/charger in a
position away from any heat source. The portable power
station/charger is ventilated through slots in the back
and sides of the housing.
• Do not operate the portable power station/charger
with a damaged cord or plug.
• Do not operate the portable power station/charger
if it has received a sharp blow, been dropped or
otherwise damaged in any way. Take it to a D
factory service center.
• Do not disassemble the portable power station/
charger; take it to a D WALT service center when
e
service or repair is required. Incorrect reassembly may
result in a risk of electric shock, electrocution or fire.
Disconnect the portable power station/charger from
•
the outlet and remove the battery pack(s) before
attempting any cleaning. This will reduce the risk of
electric shock. Removing the battery pack(s) alone will
not reduce this risk.
NEVER attempt to connect 2 portable power station/
•
chargers together.
• The portable power station/charger is designed
to operate on standard 120V household electrical
power. Do not attempt to use it on any other
voltage.
• This device is CAN ICES-3(B)/NMB-3(B) compliant.
• This device complies with Part 15 of the FCC Rules and
Industry Canada License-exempt RSS standard(s).
Operation is subject to the following two conditions:
ʵ This device may not cause harmful interference, and
ʵ This device must accept any interference received,
including interference that may cause undesired
operation.
• Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
50 (15.2) 100 (30.5) 150 (45.7)
American Wire gauge
16 16 14
16 14 12
16 14 12
12 Not Recommended
WALT
e
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
ʵ Reorient or relocate the receiving antenna.
ʵ Increase the separation between the equipment
and receiver.
ʵ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
ʵ Consult the dealer or an experienced radio/TV
technician for help.

WARNING: Shock hazard. Do not allow any liquid
to get inside a charger or the portable power station/
charger. Electric shock may result.

WARNING: Burn hazard. Do not submerge the
battery pack in any liquid or allow any liquid to
enter the battery pack. Never attempt to open the
battery pack for any reason. If the plastic housing of
the battery pack breaks or cracks, return to a service
center for recycling.

WARNING: Burn hazard. To reduce the risk of injury,
charge only D WALT rechargeable battery packs.
e
Other types of batteries may overheat and burst
resulting in personal injury and property damage.
NOTICE: Under certain conditions, with a stand-alone
charger or portable power station/charger plugged
into its power supply, the charger or portable power
station/charger can be shorted by foreign material.
Foreign materials of a conductive nature, such as, but
not limited to, grinding dust, metal chips, steel wool,
aluminum foil or any buildup of metallic particles
should be kept away from the charger and portable
power station/charger terminals. Always unplug the
charger and portable power station/charger from
its power supply when there is no battery pack in the
terminal. Unplug the charger and portable power
station/charger before attempting to clean.

Light Indicators

Refer to the indicators below for the charge status of the
battery pack.
English
5