Fulgor Milano SOFIA PRO 30 Instructions D'installation page 8

2 - Product Dimensions and Cutout Requirements
EN
2" (5.1) max. protusion from
wall for gas or electrical supply
**NOTE: Ensure your installation also complies with local and national building and fire codes.
If the surface of the entire back wall above the range and below the hood is not composed of a non-combustible material
then the 9" accessory back guard must be used.
*Consult local code for exact location requirements.
OPENING WIDTH
Range 30"
Range 36"
Range 48"
Note: Clearances from non-combustible materials are not
part of the ANSI Z21.1 scope and not certied.
Clearances to non-combustible materials must
conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI
Z223.1/NFPA 54.
Minimum clearances:
Above cooking surface (above 36" [91.4 cm])
• Sides - 6" (15.2 cm)
• Within 6" (15.2 cm) side clearance, wall cabinets no
deeper than 13" (33.0 cm) must be minimum 18" (45.7
cm) above cooking surface
• Wall cabinets directly above product must be a minimum
of 48" (122 cm) above cooking surface, no deeper than
13" (33.0 cm).
• Rear - 0" with 9 " backguard; 0" with non-combustible
rear wall.
• Below cooking surface (36" [91.4 cm] and below)
4
CUTOUT REQUIREMENTS
Min. 30" (76.2)
To bottom of
ventilation hood
Min. 18" (45.7)
Min. 6"
(15.2)
A & C B
30" (76.2) 6" (15.2)
36" (91.4) 7" (17.8)
48" (122 ) 7" (17.8)
C
Min. 48" (122)
Max. 13" (33)
Minimum to
combustibles when
no ventilation
hood is present**
Min. 18"
(45.7)
Min. 6"
A
(15.2)
3" (7.6)
GAS ELECTRIC
B B
4" 3/4 (12.3)
• Install with zero clearance between adjacent combustible
construction below the cooking surface and the back
and sides of the appliance.
ADDITIONAL CLEARANCES:
For island installation, maintain 2-½ in. minimum from
cutout to back edge of countertop and 3 in. minimum from
cutout to side edges of countertop (see top view).
For installation in a stepped island, 12" (30.5 cm) minimum
clearance is required from the back or sides of the range to
a combustible riser. The island installation is not part of the
ANSI Z21.1 scope and not certied.
FLUSH ISLAND INSTALLATION
min 3" (7.6)
*Suggested location
of utilities
BACK
min 2 1/2" (6.3)
min 3" (7.6)