Télécharger Imprimer la page

Makita DHR164 Manuel D'instruction page 8

Perforateur sans fil
Masquer les pouces Voir aussi pour DHR164:

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
Side grip (auxiliary handle)
1
5
2
4
3
007370
CAUTION:
Always use the side grip to ensure operating
safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.).
This chuck lubrication assures smooth action and longer
service life.
Installing or removing the bit
Clean the bit shank and apply bit grease before
installing the bit.
1
2
001296
Insert the bit into the tool. Turn the bit and push it in until
it engages.
6
1. Grip base
2. Side grip
3. Loosen
4. Tighten
5. Teeth
6. Protrusion
1. Bit shank
2. Bit grease
1
2
007372
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
2
007373
Depth gauge
1
015183
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole in the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip.
NOTE:
The depth gauge cannot be used at the position
where the depth gauge strikes against the gear
housing.
8
1. Bit
2. Chuck cover
1. Bit
2. Chuck cover
1. Depth gauge

Publicité

loading

Ce manuel est également adapté pour:

Dhr165