ADURO 14 Mode D'emploi page 31

If the stove is positioned against a brick wall or other non-flammable material, there are no minimum distance
requirements. To facilitate cleaning and for the best use of the convection air, we recommend that you leave
a distance of approximately 5-10 cm to the wall.
If the wood burning stove is to be placed close to flammable material such as a wooden floor or carpet, it
must be placed on a non-flammable base. The floor plate should extend for at least 30 cm in front of the
wood burning stove and 15 cm on each side measured from the opening of the combustion chamber.
Please ensure that all local rules and regulations are complied with, including CE marking of the flue pipe.
Additionally, distance requirements to flammable material for the pipe must be respected.
The wood burning stove must be installed on a floor with the adequate load-
bearing capacity. If the existing construction does not meet this requirement,
appropriate adaptation measures must be taken (e.g. a load-distributing plate).
2.2 Pipe connection
Aduro 14 & 14.1 leaves the factory with the flue outlet mounted on the top. A flue pipe with an internal
diameter of 150 mm should be used for Aduro stoves.
2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney, a curved flue pipe via the top outlet should be used. After
measuring, a hole is made in the chimney in which the pipe sleeve is placed and stove mortar is used to seal
it in place. The stove is placed in position and the flue pipe is put in place. A thin gasket is placed between
the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude into the pipe sleeve, but
must not block the opening in the chimney (see the illustration below):
The stove can be connected to a chimney to which other heat sources are connected.
X
31