Plum FIXATION OAZO Mode D'emploi page 26

- Method 3: This method is a lot easier if you are equipped with Quick-Step
technology inserts. Place the toe of your boot onto the toe piece horizontally.
Then push down, until the toe piece fastens and both inserts (1) fit into the
boot tip inserts (16).
- Method 4: Make sure your heelpiece is in low position. Bring your boot heel
against the heelpiece keeping the tip a little bit elevated. Then push down onto
toe piece with the toe of the boot until the clamp fastens and both inserts (1)
fit perfectly in the boot tip inserts (16).
WARNING: When stepped in, pull up the locker (3) to place it in WALK mode.
Then tie on the safety leashes.
HOW TO STEP IN SKI MODE?
# If your boot is out of the binding
At first, rotate the heelpieces in order to place them in SKI Mode. Then step-
in according to one of the 4 procedures described in the previous chapter.
Push your heel down until the boot heel inserts (15) are locked in the heel pins
(13).
WARNING: Once stepped into the heelpiece you must place the locker (3) in
SKI mode. And tie on your safety leashes.
# If you are already in WALK Mode
Rotate the heelpiece to the SKI mode (descent), then, push your heel down
until the boot heel inserts (15) are locked in the rear pins (13).
WARNING: Once stepped in the heelpiece, be sure that the locker (3) is in SKI
mode. And tie on your safety leashes.
HOW TO STEP OUT THE BINDINGS:
# From the WALK Mode, push down with either your hand or your ski pole on
the locker (3), until the toe piece opens. The front pins (1) will then retract
from the boot tip inserts (16).
# From the SKI Mode, push down with either your hand or your ski pole on the
locker (3), until the toe piece opens. The front pins (1) will then retract from
the boot tip inserts (16).
It is now possible to elevate the toe of your boot and rotate to the right and
left in order to remove the boot from the heel pins.
12 | P a g e
User Manual