Plum FIXATION OAZO Mode D'emploi page 25

In the HIGH position, the heel part of the boots must be positionned on the
second heel riser (11).
In such a position, the toe piece must be set in WALK Mode.
To switch from one position to the next, follow this method:
Elevate your boot so as not to be in contact with the heelpiece.
-
By using your hand or your ski poles, flip the second heel riser.
-
SKI Position (descent)
In SKI Mode, the heelpiece is rotated in order to have the pins facing towards
the front of the ski. These pins are the ones into which the boot steps.
In such a position, the toe piece must be in SKI Mode.
HOW TO STEP IN WALK MODE?
Make sure the toe piece clamp (1) is open. If closed, push the locker (3) down,
until the toe clamp opens.
Make sure the heelpieces are in one of the two uphill positions.
Check nothing is present under the toe piece or the ski and clean any foreign
material from your boot sole.
Find out which out the four following methods suits you:
- Method 1: place the toe of your boot over toe piece, keeping the heel a little
bit elevated, pushing down until the two front pins (1) fasten into the boot tip
insert (16).
- Method 2: place the toe of your boot over the toe piece, keeping the heel a
little bit elevated, and then rotate your boot in order to fit one of the front
inserts (1) in the boot tip insert (16). Then push boot down flat until the toe
piece fastens and both inserts (1) perfectly fit the boot tip inserts (16).
User Manual
11 | P a g e