Positioning - SPM GT Push 2 Manuel D'utilisation

Data di emissione: Dicembre, 2018
Fig. 1
Fig. 2

6. POSITIONING

FOR MAINTENANCE WORKER ONLY
The installation and subsequent servicing
operations must be carried out by skilled
members who have been trained to use the
device and
regulations in force.
a) Remove the packing (fig.1) and preserve it
in order to reuse for winter storage.
All the parts of the packaging must be kept
beyond the range of children, as they might
represent a potential safety/health risk.
b) Make sure
condition.
b) Rest the machine on a sturdy, flat surface
making sure it is well ventilated by leaving a
gap of 8 inches around it and do not install it
near heat sources (fig.2); we recommend you
to maintain a room temperature between
75 and 90°F.
Keep the machine venting openings free
from any kind of obstacles.
c) Check that the power mains voltage meets
the specifications
identification plate and that the output available
meets the device's power requirements.
Fit the plug into an earthed socket, removing all
multiple adaptors.
d) The installation must be carried out in
accordance with the manufacturer's instructions.
Failure to comply with the positioning and
installation instructions
machine's operation.
You are legally required to provide a suitable
grounding system for the equipment.
Before carrying out any cleaning and/or special
maintenance on the device, make sure it is
disconnected from the mains by unplugging it.
In the event of a breakdown or malfunctioning,
switch off the device and remove the plug.
Revisione: 2
in compliance
!Caution!
the machine is
!Caution!
on the
may impair
Important
Pag. : 26/68
with the
in perfect
equipment
the