Cleaning; Technical Data; Disposal - Sanitas SMA 50 Mode D'emploi

When filing, always work from the outside of the nail towards the tip!
Always check results regularly during treatment. As soon as the application becomes un-
pleasant, stop the treatment.

4. cleaning

Before cleaning the power unit, always unplug it from the socket outlet!
– C lean the instrument with a slightly moistened cloth. You can also moisten the cloth with mild
soap suds to remove more stubborn dirt.
– I f necessary, for reasons of hygiene, the attachments can be cleaned with a cloth or brush
moistened with alcohol. Dry them carefully afterwards.
– Do not drop the instrument.
– M ake sure that no water enters the instrument. But if this should happen, do not use the
instrument again until it is completely dry.
– Do not use chemical detergent or scouring agents for cleaning.
– Never immerse the instrument or plug-in power unit in water or other liquids.

5. technical data

Power unit voltage Input:
Speed:

6. Disposal

Please dispose of the device in accordance with EC Directive – WEEE (Waste Electrical
and Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.
D – cylindrical milling cutter
Grinding of lignified foot nail surfaces as well as smoothing of these. For
this purpose, apply the milling cutter horizontally to the nail surface and
remove the unwanted layer of nail using slow circular movements.
e – Flame milling cutter
For removing ingrowing nails. Carefully guide the flame cutter up to the
part to be treated and remove parts of the nail as necessary.
F – Sapphire milling cutter, round
This accessory attachment is for the careful removal of corns. When using
this attachment, please remember when removing the layer of skin from
the corn that you will quickly penetrate deeper into the skin and this could
injure the periosteum.
100-240V AC / 50/60Hz / 0.3A
Output: 21V DC / 200mA
2400-6100 r.p.m 12%
10