Qlima D 416 Mode D'emploi page 60

DRAINAGE OPTION
OPTION 1 EMPTYING MANUALLY
Notes:
• Do not remove the bucket when unit is in operation or has just stopped.
Otherwise it may cause some water to drip on the floor.
• Do not use the hose if using water bucket to collect water. When the hose is connected,
water will be drained out through it instead of into the bucket.
1
Picture 3
2
Picture 4
3
OPTION 2 GRAVITY DRAIN HOSE
1
2
Picture 5
G
3
4
60 60
Hold the handles on both sides of the water bucket and pull it out following the
arrow direction. (Attention: Pull out the bucket carefully in case the water may spill
out from the bucket and onto the floor.)
Empty the bucket by grasping the handle on the top of bucket with one hand and
grasping the bottom of bucket with the other hand.
Replace bucket in the dehumidifier according to the arrow direction.
Hose is not provided, so user shall prepare it in advance.
[Size: The hose should have an inner diameter of 14mm]
Remove bucket from the unit as instructed.
Open the drainage cover and then install the drainage joint on the drainage outlet
tightly along the arrow direction.
NOTE!
The drainage joint is with sealing gasket. Before installing the drainage joint,
reinstall the gasket on the drainage joint if it dropped. Otherwise, there will be
water leakage phenomenon.
Insert the drainage pipe into the drainage point.
Picture 6