Publicité
Les langues disponibles
Les langues disponibles
EN
For polishing, #013545:
For polishing, cleaning and wax coating
Super pad discs 400 mm, 20 mm
For initial cleaning, #013546:
For cleaning strong soiling
For maintenance, #013547:
For coarse cleaning and removing soil
For polishing, #013334:
For polishing, cleaning and wax coating
Shampoo Brush #013506:
With soft brushes for cleaning textile floorings
Perlon brush #013507:
With hard brushes for initial cleaning of linoleum, PVC,
stone, ceramics, etc.
Polish brush, cocofibre #525560:
For cleaning and polishing of linoleum, PVC, stone,
ceramics, etc.
Scrubbing brush #525590:
For maintenance of linoleum, PVC, stone, ceramics, etc.
For coarse soiling and encrustation
ATTENTION
Due to the multitude and the continuous further develop-
ment of building materials, only one basic recommendation
for use can be made.
It is therefore recommended to carry out a test with the
planned tools on every construction site.
Please note that diamond abrasives are only suitable for
machines with an output of 1700 watts or more are released.
If you have any questions, please contact your Wolff
specialist consultant or Wolff Technical Customer Service.
4.0 Use
4.1 Switching on
Mount discs or brushes as described in 3.2.
► Use the large right lever (3) to move the handle to the
working position.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 7062-91556-0 | Fax: +49 7062-91556-41 | www.wolff-tools.de
22
► The handle (5) should be at hip height of the user.
► Slightly lift the handle (5) so that the machine is level
on the ground.
► Press the release button (1) on the back of the hand
guide.
► Switch on the machine with the levers (2) on the under-
side of the handle.
After switching on the machine, the handle will move short-
ly to the right. This is completely normal.
4.2 Steering the machine
► The direction in which the machine runs is determined
by raising and lowering the hand guide.
The more the hand guide is raised or lowered, the
faster the machine runs in the corresponding direction.
► lifting the grip: machine runs to the right
► lowering the grip: machine runs to the left.
If you feel unsafe or cannot control the machine just
release lever (3). The machine will stop at once.
If you have carried out some training, you will be able
to operate the machine with one hand.
4.3 Operation with extraction.
Note: For technical reasons, the dust extractor cannot
remove the abrasive material from the floor. They
will only ever remove the flying dust. For floor cleaning
you need an industrial vacuum cleaner with special floor
nozzles.
4.4 Operation with cleaning tank
The cleaning tank is attached to two brackets on the shaft
of the guide rod.
► Place the tank on the lower holder (8) Pic D.
► Lock the tank with the upper holder (7).
► Insert tube shown in Pic G
- Guide the chain through the hole (Pic E)
- Attach the ring to the lever (Pic E)
► Screw the chain onto the lifting rod.
Publicité
