Publicité
Les langues disponibles
Les langues disponibles
EN
3.0 Maintenance
3.1 Mounting stem (pic C)
The grinding machine TANGO is shipped in 2 separate
boxes. Mount the handle with 4 screws to the machine.
Connect the cable to the socket (11) in the housing.
3.2 Mounting disc holder, pads and brushes (pic B)
Lay the machine down on the handle. Thus the support of
the discs is accessible.
The plate is centered on the drive mechanism and fixed
by turning it counterclockwise.
The brushes are placed in the same way in the middle.
Fixed by turning counterclockwise.
3.3 Assembly of the suction (pic H+I+J)
The retainingbasket of the suction is attached to two
brackets on the shaft of the stem.
► Release upper plastic holder (7) and push upwards
► Insert the holding basket of the vacuum cleaner in the
lower plastic holder (8).
► Push the upper plastic holder (7) downwards until the
holding basket is fixed and tighten again.
► Insert the cable into the socket (6) on the handle
► Push the fabric cuff (pic I+J) of the suction ring from
below over the housing of the machine and screw tight
with the two clamping straps. Connect the hoses with
the suction. (pic H)
Application:
Insert the driving plate or brushes as described.
► Use the large right lever (1) to bring the handle and the
hand guide (2) into working position.
► The hand guide should be at hip height.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 7062-91556-0 | Fax: +49 7062-91556-41 | www.wolff-tools.de
20
► Raise the hand guide slightly so that the machine is
level on the ground.
► Press the safety button (3) on the back of the hand
guide.
► Switch on the machine with the appropriate lever (4) on
the underside of the grille
► After switching on the machine the handle will turn to
the right. this is completely normal.
3.4 Dust seal ring for external extraction (pic K)
Place the machine over the dust sealing ring and connect
the nozzle to the vacuum cleaner.
3.5 Assembly of the cleaning tank (pic D)
The basket of the cleaning tank is attached to two
holders on the shaft of the handle.
► Release upper plastic holder (7) and push upwards
► Loosen the tank in the lower plastic holder and push it
upwards.
► Push the upper plastic holder (7) downwards until the
tank is fixed and tighten again.
► Insert hose as shown in picture G
► Attach chain as in picture E+F
3.6 Use of the grinding, milling and cleaning
controllers
For the grinding machine TANGO we offer a variety of
attachments and plates. To help you choose the right
attachment for your application, we would like to give you
a few recommendations.
The short overview is a guideline for the application and
the recommended attachment or plate. See 3.7 for a
detailed description of each plate and disc.
Publicité
