Wiring And Connections; Connecting The Accessories - Clarion M502 Mode D'emploi Et Manuel D'installation

7) Wiring and Connections

External microphone
(RCB-199:Sold by
separately)
(Black)
Wired remotes (connect to external Wired Remote Control Unit)
Antenna
(Black)
(Black)
(Black)
SiriusXM
18
M502
White
Black Rear audio output (Left) /Subwoofer output 1
Rear audio output (Right) /Subwoofer output 2
Red
White
Gray
Left
Front audio output terminal
Right
Red
Red AUX L
AUX R
Black USB cable (connect to USB
memory/iPod device)
4 Channel Amplifier
Refer to next page
SiriusXM Connect™ Vehicle Tuner to be
connected: Sold separately
Autogood products «130»
Gray
Front Right
Gray/Black
White
Front Left
White/Black
Purple
Rear Right
Purple/Black
Green
Rear Left
Green/Black
4-Speaker system
or
2-Speaker system
Gray
Front Right
Gray/Black
White
Front Left
White/Black
Purple
Purple/Black
Green
Not used.
Green/Black
Insulate each wire

8) Connecting the accessories

• Connecting to the external amplifier
External amplifiers can be connected to the 4 channel RCA output connections.
Ensure that the connectors are not grounded or shorted to prevent damage to the
unit.
16-Pin Connector Extension Lead
(attached to the source unit)
Brown wire (Phone mute lead)
Connect to cellular phone mute lead.
Yellow wire (Memory back-up lead)
Connect directly to battery
Red wire (Power lead)
Accessory 12V
Blue/White wire (Amplifier turn-on lead)
Connect to remote turn-on lead of amplifier
Black wire (Ground lead)
Connect to vehicle chassis ground
Orange/White wire (Illumination lead)
Connect it to the car power supply terminal
for illumination
Blue wire (Auto antenna lead)
Connect it to the car power supply terminal
for antenna