Removing The Source Unit - Clarion M502 Mode D'emploi Et Manuel D'installation

Notes of installation
1. Before installation, please make sure
proper connections are conducted and
the unit operates normally. Improper
connection may result in damage to the
unit.
2. Use only accessories designed and
manufactured for this unit and other
unauthorized accessories may result in
damage to the unit.
3. Before installation, please fasten all power
cables.
4. DO NOT install the unit in the place where
close to hot area to prevent damage to
electrical components such as the laser
head.
Screwdriver
Dashboard
Mounting Bracket
5. Install the unit horizontally. Installing the unit
more than 30 degree vertically may result in
worse performance.
6. To prevent electric spark, connect the positive
pole first and then the negative pole.
7. DO NOT block the cooling fan exit to ensure
sufficient heating dissipation of this unit, or it
may result in damage to this unit.
Unit installation
Method A
1. Insert mounting bracket into dash board,
choose appropriate mounting tab according
to the gap width, bending the mounting
tab outwards with a screwdriver to fix the
mounting bracket in place.
2. Slide the unit into the bracket until you hear
a click sound.
Source unit
Support Strap
M4 Nut
M4 washer
Stud Bolt
Autogood products «130»
Method B
M5x6
Dashboard
Mounting Frame
1. Insert this unit directly to the opening of the
dashboard.
2. Place M5×6 cylindrical screw through the
holes of the mounting frame located inside
the opening to holes of the unit and fasten
the screws to left & right.
Trim ring installation
Attach the trim ring around the front panel.

6) Removing the Source Unit

Disassemble trim ring
1. Push the trim ring to right and pull out the
right part.
2. Push the trim ring to left and pull out the
left part.
Disassemble the unit
1. Switch off the power.
2. Remove the trim ring.
3. Insert the removal keys straight back until
they lock,then pull the unit out.
4. Disconnect all the wires.
M502
17