Klarstein Robuchon Mode D'emploi page 73

TROUBLESHOOTING
Problem
The device does not work
The rotary knobs have
fallen out of the holder on
the control panel
The knobs are no longer
easy to turn.
In hot air mode the fan
does not run permanently
After baking, a loud noise
can be heard and an air
flow can be observed
near the control panel
Food was not ready in the
preparation time indicated
in the recipe
Solution approach
The fuse may be faulty. Check the fuse switch in the fuse
box.
Make sure that the power plug is plugged into the
power outlet.
Check through other equipment to see if there is a
power failure.
The knobs were accidentally loosened. They can be
removed from the unit. Simply reinsert them into their
holder on the control panel and push them in far enough
to ensure that they are securely seated and can be used
again.
There is dirt under the knobs. Remove the knobs and
clean them carefully with a damp cloth. Dry them with
a dry cloth. Do not use abrasive or aggressive cleaning
agents for cleaning. Do not soak the knobs in water
and never put them in the dishwasher. Do not remove
the knobs from the holder too often, so that they remain
stable.
This is normal. The appliance works in such a way that
the heat is distributed as evenly as possible inside the
oven.
This is normal. The noise is the cooling fan, which is
automatically activated after the oven has been used
and cools down the cooking chamber faster. The
cooling fan switches off automatically after a while.
A different temperature than that specified in the recipe
has been used. After setting the temperature, make sure
that it is the correct temperature.
The amount of food used is different from that specified
in the recipe. Check the recipe again.
EN
73