Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 37

- The tool is not intended for artisanal, commercial, professional and/or industrial use (for ex.: in
public parks...).
5.2- Operation
Before any operation:
-- Always visually inspect that the product does not show signs of use or damage
-- Check that the screws, bolts and nuts are well tightened.
-- Replace any used or damaged part, and tighten firmly the screws, bolts and nuts when needed.
Important - Before starting work
- Remove the blade protection.
- Check the nylon lines proper operation.
- Repeat several times the starting and stoppage of the machine to become familiar with it.
- Make trial work on small grass area to become familiar with handling the machine.
1. Ensure that battery is charged, otherwise proceed with charging.
2. Wear appropriate protective equipment.
3. Clear working area off any objects likely to pose a hazard.
4. Inform persons to stay away from working area and machine while you are working.
5. Firmly hold tool with both hands, and always maintain a balanced and secure position.
6. Place nylon line above the cutting area. Do not make sudden movements.
7. Press on switches (2) then (12) to start operation.
8. Start operating on working area with slow left-to-right movement, working through small areas at
a time. Do not make sudden movements.
9. Never cut wet or very damp grass. Keep the trimmer away from hard surfaces.
10. Once work is finished, stop product by releasing the switch (12).
Note: do not put down product until the nylon line has completely stopped moving.
11. Replace the blade protection after use.
I
MPORTANT
T
O PROLONG THE LIFE OF YOUR ENGINE
S
TART AND STOP THE ENGINE BY PRESSING AND RELEASING THE SWITCH GRADUALLY
ATTENTION! Do not assume of your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the tool, neglecting
strict compliance to the safety instructions given with the tool.
Improper use of the tool or failure to comply with the provided safety instructions in this manual can
cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Remain alert about your surroundings and especially for any danger that you may not hear while
using the tool.
5.3- Tips
Grass trimmer - Working with the Nylon spool line
TRIMMING:
 This is feeding the trimmer carefully into the material you wish to cut.
 Tilt the head slowly to direct debris away from you.
 If cutting up to a barrier such as fence, wall or tree, approach from an angle where any debris
ricocheting off the barrier will fly away from you. Move the line head slowly until the grass is cut
right up the barrier, but do not jam (overfeed) the line into the barrier.
 If trimming up to a wire mesh or chain linked fence be careful to feed only up to wire. If you go
–
DURING OPERATION
, NOT
DO USE BY PRESSING THE SWITCH WITH JOLTS
.
.
Page 37 / 62