Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 33

WARNING: Never fit metal cutting elements.
WARNING: Never use it without the safety guard properly installed. Failure to adhere to this warning
can cause serious personal injury.
4.2.3- Protective guard
Position the protective guard on the motor housing.
Align the protective cover to the machine shaft and fix together with the screws.
WARNING! Never use the trimmer without the protective guard fully fitted.
WARNING! The protective guard is fitted with a sharp blade (for trimming the nylon line)
protected with a protector sheath.
Make sure the protector sheath is on the sharp blade before assembling the protective guard.
Remove the protector sheath before use and always replace it after use.
4.2.4- Edge protector
Insert the edging support into the holes on both sides of the motor housing.
Adjust to the desired length.
4.2.5- Handle
Fix the loop handle with bolts, washers and nuts, make sure the limit block full seated in the limit
slot (Fig. 4A & 4B).
4.2.6- Assemble shaft tube
1. Insert the tube to the hole. (Fig. 5).
2. Rotate the locking knob to fix the tube.
4.2.7- Harness
Press the lock button to attach the harness (Fig. 6A and 6B).
Fig. 4A
Fig. 5
Fig. 4B
Page 33 / 62