Selecting The Speed Range; Setting The Speed Controller; Connecting; Switching On And Stirring - Meister MRW1400-2B Traduction Du Manuel D'utilisation Original

Use the correct stirrer type suitable for
the consistency of the substances being
mixed.
Consistency stirrer type
Pasty WK 140 (included in the
Viscous WK 140 (included in the
Thick liquid
Thin liquid
Figure 3: Mount the stirrer axle.
Figure 4: Mount the stirrer.

Selecting the speed range

The speed range selection
switch is used to set whether
the stirrer is to operate at low
or high speed.
Figure 5: Select the appropriate speed
range for the substances being mixed:
Substances Consistency speed
being mixed
Mortar pasty
Plaster pasty
Adhesive viscous
Screed thick liquid
Paint thin liquid

Setting the speed controller

The speed controller is used to
set the required speeds within
the selected speed range.
Set the speed controller to the minimum.

Connecting

Make sure that the switch-on button is
not pressed and locked in place.
5451940-Ruehrwerk-man.indd 51 5451940-Ruehrwerk-man.indd 51
scope of delivery)
scope of delivery)
(accessory)
(accessory)
range
1 (low)
1 (low)
1 (low)
2 (high)
2 (high)
Connect the plug into the power socket.

Switching on and stirring

Figure 6: Hold the stirrer with both hands.
Dip the stirrer fully into the substances to
be mixed.
Figure 7: To switch on the stirrer, hold
down the safety button (4) and press the
switch-on button (3). The stirrer starts up.
Regulate the speed to a higher value. Rule
of thumb: The more liquid the substance,
the higher the speeds.
• When stirring, keep the ventilation
slots open. Jammed cooling air will
lead to overheating and damage the
motor.
• Do not pull the stirrer out of the
substance when the motor is still
running. The substance will be thrown
out, and contaminate the surrounding
and may injury eyes.
Locking the switch­on button
With the switch-on button
locked, the motor will continue
to operate even if the user
releases the button.
To lock the pressed switch-on button,
press the safety button (4) as well. Then
release the switch-on button (3) and the
safety button (4).

Switching off

General information
When you switch off the stirrer, wait
until it has come to a complete standstill.
Only then remove the stirrer out of the
substance. Pull the plug out of the power
socket.
51
22.01.21 08:26 22.01.21 08:26