Introduction - AUtec Modular Série Manuel De L'utilisateur

Industrial radio remote controls of the Modular se-
ries are used to command machines from a dis-
tance. Each industrial radio remote control is made
up of a portable transmitting unit, from which the
user can remotely control the machine, and a re-
ceiving unit installed on board the machine itself.
The transmitting unit uses radio frequencies to
transmit a coded message which contains a value
called address. Each receiving unit can only de-
code the messages coming from a transmitting unit
with the same address.
This excludes the possibility of an interference ac-
tivating any system function. If the radio frequency
transmission is disturbed, incorrect or interrupted,
the receiving unit autonomously stops the whole
system.
Each Modular series radio remote control is in conformity
with the R&TTE 99/05/CE Directive and all its essential requisites.
Each radio remote control is also in conformity with the norms
given in the EC conformity declaration supplied with this manual.
!
Autec cannot be held responsible if the radio remote control is in-
stalled on applications that are different from those permitted:
Material lifting machines (construction cranes, industrial bridge
cranes, machines for moving material in general, . . . ).
Machines installed in areas where equipment with explosion-proof
characteristics are being used.
Machines for moving, raising and transporting people.
Page 16 of 71

2 INTRODUCTION

PERMITTED USES
FORBIDDEN USES
2 - Introduction
Receiving
unit
Transmitting
unit
LIMJNMU0