!
The use of 869.700 - 870.000 MHz frequencies band has been harmo-
nised in Europe. The use of 433.050 - 434.790 MHz frequencies band
has not been harmonised in Europe yet: check for possible user's
country limitations.
For example, some European countries only permit the use of this ra-
dio equipment in the 434.040 - 434.790 MHz band.
The radio frequency of AUTEC radio remote controls is included in the group of
frequencies permitted by those European regulations that are current at the mo-
ment of radio remote control entry onto the market.
Each radio remote control is programmed by the producer in the AUTOMATIC scan
mode (producer's standard programming) or MANUAL selection mode.
When operating in the MANUAL selection mode it is possible to work at a specific fre-
quency that must be set manually by programming the dip switches in the radio mod-
ules (refer to paragraph 8 "Programming").
To set or modify this operation mode contact personnel that have been author-
ised by Autec.
When operating in the AUTOMATIC scan mode it is possible to operate at a specific
frequency, which can be changed in case of interference or conflict with other radio
equipment using the "Changing the operating frequency" procedure.
This mode avoids internal interventions on the transmitting unit and the receiving unit.
1 With the transmitting unit started (blinking green
LED):
- press the START pushbutton and keep it pressed
(a),
- press the STOP pushbutton (b),
- release the START pushbutton
2 Unlock the STOP pushbutton by
turning it as shown in the photo and re-
peat the starting procedure.
N.B.: During the work frequency changing process, the receiving unit loses radioelec-
tric connection with the transmitting unit.
After starting, some seconds may be necessary to reset connection, therefore
keep the START button pressed for about 8-10 seconds.
LIMJNMU0
7 FREQUENCIES
MANUAL SELECTION MODE
AUTOMATIC SCAN MODE
Working frequency change process
7 - Frequencies
a
b
Page 25 of 71