Publicité
19
INSTALL WHEEL STRAPS.
(if not installed earlier)
Slide the open wheel
straps onto the wheel
tray with the red
buttons towards you.
LOAD AND SECURE YOUR BIKE — (BIKE WEIGHT LIMIT IS 30 LBS.)
21
LOAD THE BIKE.
Set your bicycle in the
wheel tray with the hoop
lying flat between the
wheels. NOTE: The front
wheel of the bicycle must
rest inside the hoop.
23
IN THE OPEN POSITION, JAWS SHOULD CLEAR
THE BIKE FRAME.
Some attachments on the down tube must be removed
if the jaws cannot attach above or below them.
25
PULL STRAPS
THROUGH SPOKES.
Pull the strap through wheel spokes
on the front and rear wheels.
Do not let the strap push
against the valve stem.
28
BEFORE DRIVING AWAY:
• Check the knob.
• Check both wheel straps.
• Tighten if necessary.
Do not
overtighten!
Instruction #1033402B - Page 5 of 12
20
INSTALL TRAY END CAPS.
Raptor Aero™ can mount above
or below most attachments,
such as waterbottles.
To avoid paint wear, clean
contact points on frame
before tightening the jaws.
26
SECURE THE STRAPS.
Do not overtighten
2X
22
POSITION THE BIKE.
Raise hoop and roll
bicycle forward
as jaws meet the
down tube.
24
TIGHTEN THE RED KNOB.
CAUTION!
DO NOT
OVERTIGHTEN
THE RED
KNOB!
27
• If the wheel is still loose in the
• Insert the strap
end behind the
red tab.
• Tighten again.
• Tighten the
strap by
repeatedly
lifting the red
tab.
the strap!
29
UNLOADING BICYCLE:
Release the
strap by pushing
the red button.
RETIGHTEN STRAPS.
tray slide the strap in the tray
until it rests against the rim.
Unscrew red knob
and roll bicyle out
of hoop.
Publicité
