Publicité
AREO CROSSBARS (NON ROUND OR SQUARE)
Start here to find the Universal MightyMount™
parts that fit your crossbars.
1
INSTALL PADS TO ONE SET OF MOUNTS.
Press a pad into
the smaller bail
(marked "A").
3
PLACE THE MOUNT ONTO THE BAR, OPENING TOWARD THE FRONT OF THE CAR.
• Close and compress the
mount around the bar.
• Insert a short hex bolt
into the hex opening in
the barrel sleeve, and
insert into mount.
ALWAYS USE THE SHORT BOLT WITH SMALL BAIL — AND LONG BOLT WITH LARGE BAIL.
4
IF THE BOLT THREADS STILL DO NOT
EXTEND BELOW THE CLOSED BAIL:
• Use the larger bail (marked "B")
with longer bolt.
• Repeat step 2 and 3.
6
REMOVE THE FITTED MOUNT FROM THE BAR.
• Assemble the remaining mounts,
and carefully set them aside.
• Do not discard the unused parts (you
may use them on future vehicles).
• Continue to step 9.
Instruction #1033402B - Page 2 of 12
Press a pad into the
backbone.(You may
need to rotate the
pad to fit correctly.)
Always install
the pad on the
bail for this
fitting process.
ROUND OR SQUARE CROSSBARS,
continue to step 7.
2
ATTACH SMALL BAIL TO BACKBONE.
Use the upper hinge slot on the backbone.
backbone
Bolt
threads
MUST
extend
below the
closed bail.
EXTEND, remove the bail, and
set the end into the lower slot.
5
ATTACH THE THUMB-WHEEL:
If there is any looseness, or the mounts can slide
on the bar, follow the fitting process again.
Repeat the fitting
process until
the MightyMount™
conforms to the size of
your crossbars when
the wheel is tightened.
IF THE BOLT DOES NOT
bail
Publicité
