Publicité
16
ATTACH WHEEL TRAY TO HOOP ASSEMBLY
• Insert baseplate bolt head 8" into slot in wheel tray.
• Use the washers and wing nut to attach the hoop
baseplate onto this bolt.
• Slide the wheel tray bolt into the track at the other
end of the wheel tray.
8"
(20 cm)
17
ALL AERO CROSSBARS (NON ROUND OR SQUARE):
Combine tray/hoop assembly with Universal MightyMounts™.
long
carriage bolt
(Raptor Aero baseplate)
spacer
nut
upper pad
SPACER POSITIONING:
If your factory bars are angled, and the spacer is not
flat against the baseplate, loosen the carriage bolt and
rotate the spacer as needed. You will need to remove
the pad. Be sure to replace it once the bolt is tightened.
18
ROUND OR SQUARE CROSSBARS:
Set tray/hoop assembly onto crossbars.
• Insert two baseplate bolts up through
the SnapArounds™ and baseplate.
• Secure with elongated hex keys.
• Insert the wheel tray bolt through the
SnapAround on the other crossbar.
• Secure with short hex key.
Instruction #1033402B - Page 4 of 12
Remove the upper pads
before continuing.
• Insert a long carriage
bolt through the
Raptor's baseplate.
• Add the spacer to the
Universal MightyMount™
and secure with nut.
• Tighten with supplied
wrench.
• Reattach the upper pad.
ON SOME
SMALLER BIKES:
If the wheel straps
need to be between
the crossbars, slide
them onto the
wheel tray now.
SMALLER BIKES ONLY:
Slide the open wheel
straps onto the wheel
tray with the red buttons
towards you.
(baseplate)
SPACER
Tighten all
3 hex keys
firmly onto all
SnapArounds™.
NOTE: Hoop must rest
horizontally on tray while turning
the hex keys. When hoop is raised
the hex keys cannot be turned.
STANDARD BIKES:
Install wheel straps
outside the crossbars
after steps 18 or 19.
REAR
WHEEL
TRAY:
requires
the short
carriage
bolt.
Publicité
