HOLZMANN MASCHINEN TKS500S Mode D'emploi page 29

HOLZMANN MASCHINEN GmbH
-Adjustment of riving knife ( alignment):
The riving knife must be aligned with the saw blade,
otherwise it must be corrected. Loosen the 2 hexagon
head screws (S1) on both sides.
Align the riving knife.
Slightly tighten the hexagon head screws (S1).
Align the riving knife to the saw blade and retighten the
four hexagon head screws (S1).
Check the gap setting for the saw blade.
The distance between saw blade and riving knife must
not exceed 8 mm and must be at least 3 mm. This set-
ting should be checked and re-adjusted if necessary.
To do this, loosen the 4 hexagon head screws (2) and
adjust the height of the riving knife.
Assembly table extension


Adjust the height of the table extension:

www.holzmann-maschinen.at
Assemble the table extension (1) to the right and
left of the main table (2) with two screws (3),
washers and nuts each. Tighten the nuts lightly
by hand.
Fold out support bracket (4) for table extension
and engage table.
Place the ruler on the saw table and the table ex-
tension and align the table extension in height,
tighten with the screws on the saw table (3) and
on the support (5).
ASSEMBLY
29
TKS500S