Marmitek MegaView 121 Guide Utilisateur page 6

2. Connect the IR extender cable to the MegaView 121™ transmitter [6]
and turn the switch to IR OUT.
x
Stick the IR blaster LED near the HDMI source.
x
When positioned correctly, one blaster LED can operate all A/V devices
within the same compartment of a cabinet.
x
Experiment to find the right position before definitive attachment of the
IR receiver.
Attention! The adhesive strip may cause discolouration on certain
surfaces, or may leave adhesive residue when removed.
7. USAGE
1. Switch on the HDMI source (e.g. TV Decoder or Media Centre PC).
2. Switch on the display device (for instance HDTV or projector) and
select the appropriate input. Usually you will do this by pressing the A/V
or EXT button of your remote control.
3. You will receive images from the connected A/V device immediately.
4. The MegaView 121™ can also be used to operate the HDMI source
from another room, by pointing your own remote control at the IR
receiver and pressing a button.
6 © MARMITEK