Worn Out Cover Strip No Longer In Place; Removal/Dismantling - THOMSON WM60-370ZRT Instructions De Montage Et De Maintenance

8.2.2

Worn out cover strip no longer in place

1. Fig.9: Remove the fastening screws from the sliding carriage and carefully lift the
complete carriage off vertically. Attention: Ensure that the strip holders remain lying on
the tubular profile!
2. Push the new cover strip through both strip holders (at the first one, diagonally up from
below, at the second diagonally down from above).
3. Fasten the cover strip in the fixed-bearing housing with the tension plate and the
threaded studs.
4. Clip the cover strip into the tubular section in front of and behind the adapter.
5. Shift the strip holders until they sit close to the end of the adapter, and align them on the
tubular section so as to allow for a centred run of the strip through the holders.
6. Carefully lower the sliding carriage vertically onto the adapter and fasten it (for the
tightening torque of the screws, see the table in Chapter 10 "Technical data").
7. Take care not to displace the holders, and that the treaded studs of the carriage sit
exactly in the respective holes in the strip holders.
8. Cut off the covering strip 8-9 mm longer than the tubular section (depth of insertion
pouch in cover plate 10 mm)
9. At the end next to the movable bearing, push the end of the cover strip into the bearing,
and at the same time clip it into the tubular section, beginning at the sliding carriage.
10. Fasten the covering strip by means of the clamping plate and the treaded studs.
Fig. 9:
9

Removal/Dismantling

Linear drive units may be removed only when the machine is switched off and by trained
personnel. Proceed in the reverse sequence as described in Chapter 4 "Mounting a linear
drive unit". Pay particular attention to the safety notices in this chapter.
WIESEL POWERLine ZRT
®
42/08 Maintenance
37