Heatsail DOME Manuel D'utilisation page 54

EN
Reprogramming the remote
Open the control box and locate the dimmer module.
It has 2 white wires cut-off .
(1) Switch on the main power
(2) Beware of any exposed wiring
(3) The LED indicator on the receiver will be permanently lit when
there is power.
If there is no lit LED indicator, either the light is disconnected
or bulb is broken.
Press with ball point
to reprogram.
Dimmer has 2 white wires cut off .
Register transmitters with the recipient
(1) Press on the connect button for 1 second with a pen. The search mode
will be active for 15 seconds and the LED indicator on the receiver will
fl ash slowly.
(2) Send an on-signal by pressing the '1 - ON' button on the remote whilst
the search mode is active in order to store the applicable transmission
code in the receiver's memory. This will normally be the button at the top
left. You can also choose a diff erent button.
(3) The connected lights will switch on/off 2x to confi rm the code has
been stored.
Repeat this procedure to register several remotes, if so required. The
receiver can store 6 diff erent transmission codes in its memory. The
memory will be retained if you install the receiver somewhere else or if
the power goes off .
54 Heatsail DOME®