Heatsail DOME Manuel D'utilisation page 35

EN
3.2. Replacing the bulb
Your DOME® is supplied with a R7S 230V/120 Watt (78mm) halogen bulb
as standard. The maximum permitted output power is 120 Watt.
The electrical supply must be disconnected via the installation's mains
switch or by disconnecting the plug before the bulb can be replaced.
You can replace the bulb by carefully sliding the glass upwards. Use tools
like a screwdriver to hold the glass up. The bulb is held in place by a
spring. Take the bulb out by first pushing it to the left or right and thereby
releasing it from its socket. Subsequently insert another bulb. Please be
careful never to touch the halogen bulb with your own bare fingers, as this
will significantly reduce the bulb's life.
3.3. Inspection
The DOME® must be subjected to an annual inspection.
The user is not authorised to carry out his own inspections and repairs.
Inspection of the DOME® must exclusively be carried out by qualified and
authorised technicians, in accordance with Heatsail's applicable standards
and regulations. Qualified people are understood to mean: people who
have completed a technical training course for the installation of outdoor
heating and who are familiar with the applicable electricity laws and
regulations.
The electrical supply must be disconnected via the installation's mains
switch or by disconnecting the plug before any work can be carried out.
All repairs must be requested via Heatsail.
A repair is only valid when original parts have been used.
The entire control panel should be returned in case of a defective cable,
once written approval has been provided by Heatsail.
Heatsail will not be held responsible for damage resulting from non-com-
pliance with the instructions regarding maintenance.
User manual 35