Heatsail DOME Manuel D'utilisation page 52

EN
8. Troubleshooting
The light does not work
Switch of power. Lift the glass of the the Dome upwards. put something
underneath to keep it upwards. Now you have access to the halogen
bulb. Verify it is well inserted and not broken. If you need to change the
bulb replace it with a standard R7S 78mm, 120W. Use a cloth or gloves
to replace the bulb, touching it with hands shortens the life considerably.
If the problem is not solved, verify that the blue and brown wires are well
inserted in the connection block. Refer to step 7.
If still not working try to reprogram the remote. (see further)
No heat
None of the heating elements are working. Check your power (set to
ON). Verify all wires are well connected. (Step 7)
Heater is only partly working
Either 3 side elements, or 2 side elements and bottom element.
Black or Grey wire not well connected. (Step 7)
Nothing works
Verify all wires are well inserted in the connector block. (Step 7)
No Music
Make sure all wires are well connected and colors match.
If there is still no sound, unplug the power. Lift the outer foot box of
the DOME® and pull out the control box. Verify the power cord is
disconnected from the outlet.
Open the control box and locate the small electronics board. Check that
all the connections on the board (see below) are well inserted:
• The speaker connections (A & B on the board).
• The power plug (C)
• (D) If the led is alternating between blue and red this means the
bluetooth device is working and it is looking for a connection.
• If the led is blue this means the bluetooth is working and is
conneced to a device.
52 Heatsail DOME®