SOMFY ELIXO 2000 230V RTS Manuel D'utilisation page 9

ELIXO 2000 230V RTS
2. PRODUCT DESCRIPTION
This motorisation is exclusively designed for installation with a sliding gate
for residential use.
3. USE AND OPERATION
3.1. Normal operation
3.1.1. Total opening with a 2 or 4-button remote control
3.1.2. Obstacle detection mode
When an obstacle is detected during opening or closing, the gate will stop
and reverse.
3.2. Specific operation
3.2.1. Pedestrian opening
3.2.2. Active safety edge
If an obstacle is detected while the gate is closing/opening, it stops, then
re-opens partially.
3.2.3. Photoelectric cells
With cells active when closing:
• If an obstacle is detected while the gate is closing, it stops, then
re-opens fully.
• If an obstacle is detected when opening, the gate will continue its
movement.
With cells active when opening:
• If an obstacle is detected when opening, the gate will stop until the
obstacle is removed.
• If an obstacle is detected when closing, the gate will continue its
movement.
3.2.4. Operation in sequential mode with automatic
closing a er a time-delay
In sequential mode with automatic timed close:
• when open, the gate closes automatically a er the programmed
timeout
• when moving, pressing the button on the remote control interrupts
the movement in progress then the gate closes automatically a er
the programmed timeout.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
3.2.5. Operation in semi-automatic mode
• pressing the button on the remote control while the gate is opening
• pressing a button on the remote control during closing causes it to
3.2.6. Automatic
In automatic mode, the final position of the gate will always be the closed
position.
• The gate closes automatically a er the programmed timeout
• pressing the button on the remote control during opening has no
• pressing a button on the remote control during closing causes it to
• if an obstacle is located within the detection zone of the cells during
3.2.7. Automatic + cell blocking
During and a er gate opening, movement in front of the cells (safe clo-
sure) will close the gate a er a short timeout (fixed at 3 seconds).
STOP
If there is no movement in front of the cells, the gate will close automati-
cally a er the timed close programmed.
4. UNLOCKING/LOCKING THE
MOTORISATION
4.1. Unlocking the motor
STOP
1) Insert the key into the lock.
2) Turn the key a quarter of a turn to the le .
3) Turn the release handle to the right.
4.2. Locking the motorisation
1) Turn the release handle to the le .
2) Move the gate manually until the drive mechanism re-locks.
3) Turn the key a quarter of a turn to the right.
4) Remove the key.
will stop the gate
reopen
effect,
reopen
the timeout, the timeout is reinitialised once the cells are cleared.
Attention
Operation to be carried out with the power off.
2
The key cannot be removed from the lock until the handle has been
returned to its initial position.
Attention
Do not forcibly push the gate. Hold the gate over its entire travel
during manual manoeuvres.
3
1
EN
3