Using Your Appliance; Using The Programmer; º How To Set The Time; º How To Adjust The Time - Brandt FC641WW Guide D'utilisation

99638333_A_ML.qxp 16/01/2007
EN

4 / USING YOUR APPLIANCE

USING THE PROGRAMMER

• •
• How to set the time
- -
When supplied with electricity
The display flashes at 12:00 (fig.1)
Set the time using the + and - buttons (holding
down the + or - makes the numbers go faster)
(fig.2).
Example: 12:30
Press the " " touch control to validate.
The display stops flashing (fig.3).
• How to adjust the time
- To set the time on the clock
The function selector switch must be in the 0
position (fig.1).
Hold down the "
seconds until 0.00 appears. Keep held down
until the time appears again, then let go
(fig.2).
While the time is flashing, set the time using
the selector (fig.3).
Press the " " touch control to validate
(fig.4).
Warning
If there is no confirmation from the
" " button, the time is recorded auto-
matically after a few seconds.
14:59 Page 56
" button for a few
56
fig.1
fig.2
fig.3
fig.2
fig.3
fig.4