Programming Procedure - tecnodent Sting Mode D'emploi

PROGRAMMING PROCEDURE

This function is only available on chairs equipped with such feature.
1. Let the chair reach the automatic reset to "zero" position, by tapping the "0" button in the foot control.
2. Let the chair reach the desired position, using the foot control (see paragraph 4.3).
3. While keeping the M button pressed, tap the joystick upward (position "1"), right (position "2") or left (position "3") or the but-
tons "P1", "P2" and "P3" on the remote control, according to the program number you have selected . A sound-signal
(BEEP) confirms that the working position has been memorized. Any time you tap the joystick upward, right, left again or
the buttons "P1", "P2" and "P3" on the remote control, the chair moves automatically to the programmed working position
you have selected.
NOTE.
To avoid losing the programmed position, it is recommended to regularly set the chair to its "zero" position, by us-
ing the "0" function at any patient change.
– 31 –
Operating instructions