3.1. U
NPACKING
To remove the cardboard box, it is necessary to cut the straps and to unscrew the screws located in the lower part of the box.
FIG. 4
3.2. S
UPPLY STATUS
Inside the packaging you will find the following items:
A Sting chair;
An operating instruction manual;
A warranty certificate;
A bottle of fabric cleaner;
In case of mistake or missing parts, contact the dealer to manage the problem.
3.3. H
.
ANDLING
To remove the chair from the wooden pallet, first take the two caps off, then unscrew the two screws which fix the chair
base to the pallet (see figure 4).
To move the chair from the wooden pallet employ two people.
To move the chair it is necessary to use the dedicated handles, provided to the installation service on request.
3.4. I
NSTALLATION
3.4.1.
Typical installation.
Proceed as follows:
1.
Be sure that the installation site conforms to local regulatory technical requirements for rooms suitable for medical use or
specialized surgery;
2.
Be sure that the electrical system of the cabinet has a good earthing and a residual-current device system;
3.
Be sure that the main supply of the electrical wiring of the cabinet corresponds to the one of the identification label;
4.
Check that the fuses, located at the front side of the chair near to the base, are correctly fixed, because during transport
they could have become loose;
5.
Insert the plug into the socket;
6.
Activate the chair switching the main switch on. Now the chair is ready to work. In case of non operation of the chair, refer
to section 6 about trouble-shooting;
7.
If needed, drive the chair to a comfortable height and assemble, if provided, the unit bracket and the bracket itself, following
the instructions of the manufacturer.
NOTE.
Equipment is intended neither for use in potentially explosive environment, nor in rooms not protected against
weather conditions. Not intended for use in altered atmospheres.
3. INSTALLATION
.
.
.
– 27 –
Operating instructions