Publicité
⑩ EFFECT Fader Control
Adjusts the signal level of internal effects to the MAIN bus.
⑪ PHANTOM +48V switch
This switch toggles phantom power on and off. When the switch is on, the mixer supplies +48V phantom
power to all channels that have XLR mic input jacks. Turn this switch to on when using one or more
phantom-powered condenser microphones
NOTE: When this switch is on, the mixer supplies DC +48V power to pin 2 and 3 of all XLR type MIC INPUT
jacks.
CAUTION: Be sure to leave this switch OFF if you don't need phantom power.
When turning the switch to ON, be sure that only condenser microphones are connected to the XLR input
jacks. Devices other than condenser mics may be damaged if connected to the phantom power supply.
Please note however that the switch may be left on when connecting to balanced dynamic microphones.
To prevent damage to speakers, be sure to turn off power amplifiers (or powered speakers) before
turning this switch on or off. We also recommend that you turn all output controls (stereo out, Master
fader, GROUP 1-2 fader, GROUP 3-4 fader, etc) to their minimum settings before operating the switch to
avoid the risk of loud noises that could cause hearing loss or device damage.
⑫ PHONES Control
Adjusts output level of jacks (4).
⑬ 2TR IN (TAPE)
Adjusts the input signal of TAPE to MAIN.
⑭ Level Meter
This LED meter displays the level of the signal output from the MAIN and the PHONES. It displays MAIN
level when it doesn't light. It displays PHONES level when it lights.
⑮ POWER indicator
This indicator lights when the mixer's power is ON.
⑯ MAIN OUT Master Fader
Adjusts the signal level sent to the MAIN OUT jack.
REAR PANEL:
① POWER
AC power input: Properly insert the power adaptor (supplied).
② Power switch
24
Publicité
