6 Before Operation
When connecting the device to the power sup-
ply (via external power supply unit or PoE), the
status LEDs (8) light up briefly in the following
order:
1) 2 – SYSTEM BOOTING
2) 1 – MASTER and 2 – SYSTEM BOOTING
3) 1 – MASTER and 4 – SYSTEM READY
When the speaker is set up in the Dante net-
work as a clock slave, the following LEDs are
permanently on:
3 – SLAVE and 4 – SYSTEM READY
If both LEDs 1 and 2 flash, a connection error has
occurred . In this case, disconnect WALL-05DTM
from the power supply (or PoE connection) and
reconnect after a minimum of 30 seconds .
6.1 Level adjustment
The speaker itself has no control elements . The
volume is adjusted via an audio signal from a
Dante signal source (transmitter) with a corre-
sponding digital level value .
Only set the signal level at the audio source to
such a value that the signal from the speaker
is not distorted .
Note: The maximum possible signal level de-
pends on the level of the supply voltage used .
The higher the supply voltage, the higher the
level values that can be reproduced without
distortion .
CAUTION Never adjust the audio system to
a very high volume . Permanent
high volumes may damage your
hearing!
14