Télécharger Imprimer la page

Monacor WALL-05DTM/WS Mode D'emploi page 10

Publicité

Les langues disponibles

Les langues disponibles

Active Speaker
for Dante Networks
These instructions are intended for audio system
installers with knowledge of network technol-
ogy . Please read the instructions carefully prior
to operation and keep them for later reference .
The figures relating to the text below can be
found on page 2 .
1 Overview
1 Speaker
2 Screws for fastening the speaker to the
bracket
3 Metal bracket
4 Plastic support
5 RJ45 jack IN PoE to connect the speaker to
the network (Ethernet) and to supply the
speaker with power via the network (e . g . via
a network switch with PoE power supply) .
The two LEDs at the jack indicate connection
establishment and data communication .
6 RJ45 jack LINK to route the network connec-
tion (e . g . to an additional WALL-05DTM)
The PoE power supply, however, is not
routed via this jack . The two LEDs at the
jack indicate connection establishment and
data communication .
7 Power supply jack to connect a 19 V power
supply unit as an alternative to the PoE
power supply via the network jack (5)
8 Status LEDs
1 – MASTER
2 – SYSTEM BOOTING
3 – SLAVE
4 – SYSTEM READY
10
2 Important Notes
The product corresponds to all relevant directives
of the EU and is therefore marked with
The product corresponds to the relevant UK
legislation and is therefore marked with UKCA .
The product is suitable for indoor use only .
Protect it against dripping water, splash water
and high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
For cleaning the product, only use a dry, soft
cloth; never use water or chemicals .
No guarantee claims for the product and no
liability for any resulting personal damage
or material damage will be accepted if the
product is not correctly used, if it is not safely
installed or not expertly repaired .
If the product is to be put out of opera-
tion definitively, dispose of the product
in accordance with local regulations .
3 Applications
The compact active speaker WALL-05DTM is
suited for versatile PA applications, especially
for fixed installation (e . g . for background sound
and announcements) . The speaker is designed
as a 2-way system . The speaker features an
Ethernet interface that allows the speaker to
be integrated into a Dante audio network as a
receiver of audio signals .
The speaker is supplied with power via the net-
work connection (Power over Ethernet) or via
an additional power supply unit .
3.1 Dante
Dante, an audio network developed by the
company Audinate, allows transmission of up
to 512 audio channels at the same time . Dante
(Digital Audio Network Through Ethernet) uses
a common Ethernet standard and is based on
the Internet protocol . The transmission of audio
signals is uncompressed and synchronized, with
minimum latency . The advantage over analog
audio signal transmission is a cost-effective con-
nection of components via standard network
cables and low susceptibility to interference,
even in case of long transmission paths . In ad-
dition, signal routing between components that
.

Publicité

loading

Ce manuel est également adapté pour:

1000788