Chauvin Arnoux C.A 5231 Notice De Fonctionnement page 38

3. Connect the black lead to the COM terminal and the red
lead to « + » ;
4. Place the contact tips on the terminals of the component ;
The voltage across the terminals of the component is displayed
on screen.
3.1.5 Current measurement using a Clamp-on
Ammeter
1. Set the switch to
2. Select AC or DC by pressing
is in AC mode. According to your selection, the screen
displays DC or AC ;
3. Connect the black lead of the Clamp to the COM terminal
and the red lead of the Clamp to « + » ;
4. Place the clamp on the conductor to be measured ;
The measured current is displayed on screen;
Forward direction
;
. As default, the device
1 mV DC/1 A DC or 1 mV
AC/1 A AC clamp
English
38 - 117