Error Codes - pro-intell PRO 85 Manuel D'utilisation

8
Error
Reason
code
1.Halved banknote detected
Eh
2. Left or right sensor failure
Ec
Chained banknotes detected
Double banknote detected,
Ed
banknotes are stuck together
1. Banknote with different
width detected.
dd
2. Wrong banknote position.
Suspected note detected by
Eu
UV
Banknote lacks magnetic
En
markings
st
Counting stopped.
Solution
1. Remove the banknotes from the stacker and take
away the suspicious banknote (lying on the top).
Repeat the counting procedure.
2. Contact the service center
1. Remove the banknotes from the stacker and
repeat the counting procedure.
2. Adjust the slot (see Table 7.1.)
1. Remove the banknotes from the stacker and take
away the suspicious banknote (lying on the top).
Repeat the counting procedure
2. Adjust the slot, see Table 7.1.
3. Choose a lower sensitivity level, (see Table 7.2.3.)
4. Check the currency type (RUR, USD, or EURO
currency indicator should be on).
1. Remove the banknotes from the stacker and take
away the suspicious banknote (lying on the top).
Repeat the counting procedure.
2. Set the sensitivity level lower, (see p.7.2.4).
Remove the banknotes from the stacker, take away
the suspicious banknote (lying on the top) and repeat
counting procedure.
1. Check the currency type (RUR, USD or EURO
currency indicator should be on)
2. Put the banknotes in the middle of the hopper by
using the auxiliary hopper guide plates (Fig. 1-4)
3. Remove the banknotes from the stacker and take
away the suspicious banknote (lying on the top).
Repeat the counting procedure
Remove banknotes from the stacker, and press
"START" button

Error codes

27